IntelliPeak DirectLink WiFi User Manual

IntelliPEAK DirectLink WiFi
IntelliPEAK DirectLink Applications Guide
IntelliPEAK DirectLink can be installed to control the following loads.
Description
HVAC
Yes
Water Heater
Yes
Pool Pump
Yes
Refrigeration
Yes
It requires connection to line power and must be installed by a trained and experienced
technician. Do not under any circumstances open the door and touch any components
inside, as line voltage (120 – 240 VAC) is present. You could damage this product or cause
a hazardous condition if you fail to follow these instructions.
Need Help? For assistance with this product, please visit http://www.comverge.com or call?
HVAC
For HVAC, IntelliPEAK DirectLink is typically installed outside, near your compressor. It is
wired to the same power source as the compressor and relays inside IntelliPEAK will
intelligently reduce the compressor run time during a control event to reduce the demand on the
electrical grid during event periods. Relay(s) inside the device will interrupt the control signal
from the thermostat to the compressor and will only disable the compressor periodically during a
control event. The indoor fan will continue to run during this time. The indoor temperature is
expected to rise a few degrees during the event, depending on the amount of insulation in the
premise.

IntelliPeak DirectLink WiFi Specifications

General

Brand	IntelliPeak
Model	DirectLink WiFi
Category	Controller
Language	English

Summary

IntelliPEAK DirectLink Applications

HVAC Control Overview

IntelliPEAK reduces compressor run time during control events, allowing indoor fan to run.

Safety Warning

Warns against opening the device due to hazardous line voltage and potential damage.

IntelliPEAK Appliance Control

IntelliPEAK Features and Wiring

Cold Load Pickup

IntelliPEAK WiFi Setup

Initial Pairing and Reconnection

IntelliPEAK pairs with Wi-Fi, stores credentials, and attempts reconnection after outages.

Handling Wi-Fi Credential Changes

If Wi-Fi credentials change, IntelliPEAK enters Ad-Hoc mode to allow re-entry of new credentials.

IntelliPEAK WiFi Configuration Steps

Accessing Configuration Page

If the page doesn't auto-appear, type "DirectLink/settings" in the browser address bar.

Selecting Network Name (SSID)

Manual WiFi Setup

Manual Network Settings

Entering Security Key

Manually enter the WiFi Network Name (SSID), select security type, and enter the security key.

Completing WiFi Setup

Saving and Applying Settings

Click Save, then Apply on the overview page to connect to the network.

Configuration Completion