How to troubleshoot no audio output on Inter-m Amplifier?
If the Inter-m Amplifier is not outputting audio, verify these points: * Ensure the device is receiving power. * Confirm that the volume of the connected input channel is not muted or locked. * Check if the speaker output switch is disabled. * Make sure the external MUTE contact closure is properly connected.
What to do if the audio signal is distorted on Inter-m Amplifier?
If you're experiencing distorted audio from your Inter-m Amplifier, it could be due to the channel volume and main volume being set too high. Also, check if the bass and treble volumes are excessively boosted.
Why does Inter-m PAM-324 audio intermittently disconnect?
If the audio from your Inter-m Amplifier is cutting out intermittently, verify the following: 1. Check if the Output level Indicator is red, signaling overload. 2. Ensure the impedance of the connected speaker matches or exceeds the regulated impedance.
What to do if the RM-05A microphone does not output any sound on Inter-m PAM-324 Amplifier?
If the RM-05A microphone is not producing sound with your Inter-m Amplifier, ensure that the RM-05A CH 1~5 button is pressed. Also, check that the channel volume of INPUT 1 is not set to the minimum value or locked.
How to fix PrIOrITY MuTe not working on Inter-m PAM-324?
If the PRIORITY MUTE function isn't working on your Inter-m Amplifier, make sure the PRIORITY switches for INPUT 1 and INPUT 2 are turned on.
General| Rated Output Power | 240W |
|---|---|
| Output Power | 240W |
| Frequency Response | 20Hz ~ 20kHz ±3dB |
| Total Harmonic Distortion (THD) | Less than 1% |
| Signal-to-Noise Ratio | >100dB |
| S/N | >100dB |
| Input Sensitivity/Impedance | Mic 1~6: -50dBV/600Ω, Line 1~2: -10dBV/10kΩ, AUX 1~2: -10dBV/10kΩ |
| Input Impedance | Mic: 600Ω, Line: 10kΩ |
| Output Impedance | 4Ω |
| Power Source | AC 230V, 50/60Hz |
| Dimensions | 360mm |
To Next Page
