KEYSET FEATURES
DIRECT STATION SELECTION/BUSY LAMP FIELD (DSS/BLF) KEYS
(EXECUTIVE KEYSET ONLY)
The Executive Keyset has 12 DSS/BLF keys that provide one-key in-
tercom access to each of the 12 keysets. The lamps under the
DSS/BLF keys create a busy lamp field and flash at different
rates to indicate the status of each keyset. Each flash rate has
a distinct meaning, as described below. Flash rates are given in
interruptions per minute (IPM) or seconds on/off.
Flash Rate Indication
STEADY (constantly lit) The keyset is busy.
LOCK-OUT $LASH The keyset is in lock-out (off hook
(0.5 sec. on/3.5 sec. off) with no activity or unplugged).
SLOW FLASH (30 IPM) An outside call is recalling.
(1.0 sec. on/l.0 sec. off)
DND FLASH
The keyset is in do-not-disturb.
(3.5 sec. on/O.5 sec. off)
MEDIUM FLASH (60 IPM) The keyset is in call forward mode.
VOLUME CONTROLS
The ringer volume and speaker volume are controlled by separate
thumbwheels on the side of the keyset.
AUDIBLE SIGNALS
Off-Book ringinq: When the keyset is busy, it will ring every 6
seconds to notify the user that an intercom or transferred call
is waiting.
A short ring tone and a slow-flashing line key in-
dicate an outside call waiting; a double ring tone and a slow-
flashing SYS HOLD key indicate an intercom call waiting.
Confirmation tones:
The system produces a confirmation tone to
acknowledge that a key has been pressed on the keyset.
These
tones are heard through the handset or internal speaker for as
long as the key is depressed. DTMF tones are heard while dialing
or when a speed-dial number is dialed.
Ring Tones and Busy Signals: Ring tones and busy signals are
heard through the handset or the keyset's internal speaker.
When
the speakerphone is in use (keyset is on hook), ring tones and
busy signals normally heard through the handset are heard through
the keyset's internal speaker.
GLX Owner's Guide (Issue 1, 11/85)
Page 12
To Next Page
Loading...
