*
KEYSET FEATURES
DATA DEVICE INTERFACE (EXECUTIVE KEYSET ONLY)
The Executive Keyset has a modular jack (labeled DATA) that can
be used for connecting a data device (such as a data terminal or
personal computer) that has a direct-connection modem with an
RJll C.O. line interface. It is used to communicate with remote
data equipment through an intercom channel or outside line.
While the data device is in use, the keyset user cannot place or
receive calls. An outside call ringing in or an intercom call
camping on will not interfere with the data transmission.
To connect the data device to the Executive Keyset: Insert the
connector end of the data device interface cable into the keyset
DATA jack.
To access a remote computer using a C.O. line:
(1) Lift the
handset and press an unlit line key.
(2) Dial the telephone number or
intercom number at the remote
computer site.
(3) When you hear the modem tone, press the DATA key and hang up.
The DATA key flashes slowly.
To access a remote computer using an intercom channel:
(1) Lift the handset and press the desired DSS/BLF key.
(2) Notify the called party that you wish to connect the device.
(3) When the called party activates the remote computer by press-
ing the DATA key, you hear modem tone. Press your DATA key
and hang up. Both DATA keys flash slowly.
To terminate the connection with the computer:
EITHER,
press the DATA key. The C.O. line or intercom
channel is disconnected and the DATA key is unlit.
OR.
if you wish to speak to the party at the computer site
after the data ,transmission, lift the handset and press the
DATA key. This can only be done if the modem at the computer
site can be turned off without dropping the C.O. line.
GLX Owner's Guide (Issue 1, 11/85) Page 15
To Next Page
Loading...
