INTERCOM CALLS
D~S/BLF KEY SKIPPING (EXECUTIVE KEYSET ONLY)
Executive Keysets have DSS/BLF keys that can be used to place in-
tercom calls. If an Executive Keyset user presses a DSS/BLF key
while on an intercom call, the current call is dropped and a call
is placed to the keyset associated with the pressed DSS/BLF key.
This is faster than pressing and releasing the hookswitch and
then pressing the desired DSS/BLF key.
To use DSS/BLF key skipping: When you are finished with an in-
tercom call and wish to place another intercom call, do not hang
up.
Press the DSS/BLF key of the party you wish to call. You
are disconnected from the first call and hear the second call
ring as usual.
Note :
Pressing a DSS/BLF key and hanging up while on an outside
call transfers the outside call to the called keyset.
OUTSIDE CALLS
The following outside call features are described in this sec-
tion:
l
Receiving and Placing Outside Calls
l
Outside Dial Tone Restore and Timed Hookflash
l
Line Key Skipping
l
On-Hook Dialing of Outside Calls
RECEIVING AND PLACING OUTSIDE CALLS
To receive an outside call: When you see a slow-flashing line
key and hear a ring tone every 6 seconds (at your keyset or an-
other keyset), lift the handset and press the slow-flashing line
key. The call is connected and the line key is steadily lit.
To place an outside call:
(1) Lift the handset and press an unlit line key. If you hear a
busy signal, you tried to access a busy C.O. line or the C.O.
line you selected is restricted. Line key is lit when the
line has been accessed.
(2) Dial the desired telephone number. You may manually dial the
number or use the speed-dial or redial features. If you hear
a fast busy signal after dialing, your keyset is toll re-
stricted.
GLX Owner'% Guide (Issue 1, 11/85) Page 18
To Next Page
Loading...
