CALL FORWARDING
*
To enter your call forward number: The receiving keyset or tele-
phone number must be stored in station speed-dial location 1. If
it is a telephone number, the speed-dial location code can be
used for speed dialing and call forwarding.
(1) While on hook, press the SPDL key. The SPDL key flutters.
(2) Dial 1 for the speed-dial location.
(3) Dial a two-digit intercom number or a telephone number with
at least three digits. This is where forwarded calls will be
sent. Use intercom number 10 for the attendant.
Note :
If you make a mistake, press a line key. The original
number is retained. An invalid number is not detected until
a forward is attempted. Then, the caller hears a fast busy
signal.
(4) Lift and replace the handset.
You hear a confirmation tone
and the SPDL key is unlit.
To turn call forwarding on or off: While on hook, dial #02.
When call forwarding is enabled (on), you see a medium-flashing
SYS HOLD key. Executive Keyset
user’s
see a medium-flashing
DSS/BLF
key
for your keyset.
‘,
GLX Owner's Guide (Issue 1, 11/85) Page 31
To Next Page
Loading...
