T8 Torque Sensor Operation Manual
Interface Inc. ● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com ● Email: contact@interfaceforce.com ● 800.947.5598
Page 11 of 11
Transportation
Only release well packed sensors for transportation. The sensor should not be able to move back and forth in the
packing. The sensors must be protected from moisture.
Only use suitable means of transportation.
Storage
The storage of the sensors must occur in dry, dust-free rooms, only.
Slightly lubricate shafts and flanges with oil before storing (rust).
10
Disposal
The torque sensors must be disposed according to the valid provisions of law. For
this, see our “General Terms and Conditions”
www.Interfaceforce.com
11
Calibration
At the time of delivery, torque sensors have been adjusted and tested with traceable calibrated measuring
equipment at factory side. Optionally, a calibration of the sensors can be carried out.
Proprietary Calibration
Acquisition of measurement points and issuing of a calibration protocol Traceable calibrated measuring equipment is
being used for the calibration. The sensor data are being checked during this calibration.
DKD-Calibration
The calibration of the sensor is carried out according to the guidelines of the DKD. The surveillance of the
calibrating-laboratory takes place by the DKD. At this calibration, the uncertainty of measurement of the torque
measuring instrument is determined. Further information can be obtained from Interface.
Re-Calibration
The recalibration of the torque sensor should be carried out after 26 months at the latest.
Shorter intervals are appropriate:
• Overload of the sensor
• After repair
• After inappropriate handling
• Demand of high-quality standards
• Special traceability requirements
12
Data Sheet
See
www.Interfaceforce.com
To Previous Page
Loading...
Need help?
General