Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 165
If the selected slot is empty (the user group is not assigned), you are prompted to
select one of the available user groups.
2>Supervisor Grp
3 Area 1
Select the appropriate user group to assign to the selected user.
If the selected slot already contains a user group assigned, you are moved to the
“Change User Group” menu.
Now you can take one of the following actions:
• Change the assigned group: Press 1, or Enter, or Right to go to the user
group list and choose the appropriate group.
• Remove the assigned group: Press 2, or go the next menu entry and press
Enter.
Note: The Installer user group can only be assigned to the installer.
For more information on user groups, see “3.2 User groups” on page 168.
3.1.n.9 Select mode
Depending on the selection, the user operates on areas or area groups. The
following options are available:
• Areas. The user can only set and unset particular areas. This is the default
value.
• Area groups. The user can only set and unset particular area groups.
• All. The user can set and unset areas as well as area groups.
3.1.n.10 Delete user
To remove a user, select a user using the cursor, or by entering the user number,
and go to the Delete user menu.
The display shows:
Choose Ok and press Enter. This removes the user.
Repeat the command to delete other users, or press Clear to exit and return to
the higher menu level.
Note: You cannot delete a user unless your user group authorizes you to do so.
To Next Page
Loading...
Need help?
General
