To Next Page

To Previous Page

Chapter 5: Menu reference

238 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual

8.2.4.2 Tamper

2 Tamper

>No<

If the Tamper option is set to Yes, tamper alarms require an engineer reset.

8.2.4.3 Panic

3 Panic

>No<

If the Panic option is set to Yes, panic alarms require an engineer reset.

8.2.4.4 Confirmed alarm

4 Conf. alarm

>Off<

The Alarm confirm menu defines which AB alarm requires an engineer reset. The

available options are A-ALARM, B-ALARM, or Off (disabled). This is option works

only when AB alarm confirmation is enabled.

8.2.4.5 Battery fail

5 Battery fail

>Off<

If the Battery fail option is set to Yes, battery faults require an engineer reset.

8.2.4.6 Aux fuse

6 Aux fuse

>Off<

If the Aux fuse option is set to Yes, auxiliary fuse faults require an engineer reset.

8.2.4.7 Mains fail

7 Mains fail

>Off<

If the Mains fail option is set to Yes, mains supply faults require an engineer

reset.

8.2.4.8 Siren fault

8 Siren fault

>Off<

If the Siren fault option is set to Yes, siren faults require an engineer reset.

8.2.4.9 Interconn fault

9 Intconn fault

>Off<

If the Interconnection fault option is set to Yes, interconnection faults require an

engineer reset.

Interlogix ATS3500A-IP-MM Installation And Programming Manual

Other manuals for Interlogix ATS3500A-IP-MM