Parts Required
2 AAA batteries
Instructions
1. Push the button on the bottom of the sensor and lift the cover open
2. The alarm panel may begin to beep, you may choose to silence the alarm by entering
your code
3. Remove old batteries and replace with new ones
4. Reposition the sensor cover by placing the top part of the sensor on first and then
press down to secure the bottom into place, you should hear a click
5. Arm and disarm the alarm to clear panel alert
***If the low battery alert does not clear or if the panel shows sensor tamper, walk through
the steps above once more. It could be either the batteries or sensor cover are not on
properly***
To Next Page
Loading...
Need help?
General
