Interlogix SAW Series - User Manual

How to Replace Batteries in a GE Interlogix Door/Window Sensor Model SAW
Series
Description
This page shows battery replacement for a Door/Window Sensors model SAW Series. The
larger of the two pieces is the sensor and the smaller is the magnet.
Because there are many different versions of window/door sensors, it is important to remove
the sensor cover first to determine what kind of batteries are required for your equipment. We
advise you to check before purchasing batteries.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through myadt.ca. After logging in:
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]

Interlogix SAW Series Specifications

General

Technology	Wireless
Operating Frequency	319.5 MHz
Housing Material	Plastic
Mounting Type	Surface Mount
Category	Security Sensors
Battery Life	Up to 5 years
Compatibility	Interlogix/GE Security Systems

Summary

GE Interlogix Door;Window Sensor Battery Replacement Guide

Sensor Description

Identifies the sensor and magnet components of the Door/Window Sensor model SAW Series.

Preparation for Battery Replacement

Steps for placing the alarm panel in test mode via myadt.ca before sensor maintenance.

Battery Replacement Procedure

Required Parts for Replacement

Lists the necessary components for battery replacement, specifically 2 AAA batteries.

Step-by-Step Installation Instructions

Detailed steps for opening the sensor, replacing batteries, and securing the cover.