68 TruVision 12/32 Series IP Camera Configuration Manual
To set a preset tour:
1. In the PTZ control panel, click to enter the tour settings interface.
2. Select a preset tour number from the drop-down list.
3. Click to enter the adding interface of preset.
4. Configure the preset number, preset tour time and preset tour speed.
The dwell time. The length of time in seconds for which a
camera stays at a preset before moving to the next preset.
: The speed the camera moves from one preset to another.
5. Click OK to save a preset into the preset tour.
6. Repeat the steps from 3 to 5 to add more presets.
7. Click to save all the preset tour settings.
To call a preset tour:
In the PTZ control panel, select a defined preset tour from the drop-down list and click
to call the preset tour.
To Next Page
Loading...
