Sends an email to a specified address when there is a motion
detection alarm.
Note: You must configure email settings before enabling this
option. See “To set up the email parameters” on page 16 for
further information. If you want to send the event snapshot
together with the email, check the Attached Snapshot option.
Trigger external alarm outputs when an event occurs. Check
“Select All” or each individual alarm output.
Note: This option is only supported by cameras that support
alarm output.
7. Click Save to save changes.
Cross line detection
This function can be used to detect people, vehicles and objects crossing a pre-defined
line or an area on-screen. The line crossing direction can be set as unidirectional or
bidirectional. Unidirectional is crossing the line from left to right or from right to left.
Bidirectional is crossing the line from both directions.
A series of linkage methods can be triggered if an object is detected crossing the line.
Dual-VCA (Video Content Analysis)
When Dual-VCA mode is enabled, the camera sends video analytics results (meta data)
to an NVR or other platforms to generate a VCA alarm.
For example, with an Interlogix NVR (please check Interlogix website for the latest NVR
models supporting this feature), you can draw a virtual line in the NVR playback
window, and search the objects or people crossing this virtual line.
Note: Only cross line and intrusion detection can support dual-VCA mode.
To Next Page
Loading...
