Interlogix TruVision TVC-1201 - Audio Exception Detection

TruVision 12/32 Series IP Camera Configuration Manual 37
Notify Alarm Recipient
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Sends an email to a specified address when there is a face
detection alarm.
Note: You must configure email settings before enabling this
option. See “To set up the email parameters” on page 16 for
further information. If you want to send the event snapshot
together with the email, check the Attached Snapshot option.
Upload Snapshot
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Note
: To upload the snapshot to NAS, you must first configure
the NAS settings. See “NAS settings” on page 48 for further
information.
To upload the snapshot to an FTP, you must first
configure the
FTP settings. See “To define the FTP parameters” on page 15
for further information. Enable the Upload Type option.
To upload the snapshot to FTP and NAS when motion
detection or an alarm input is triggered, you must also enable
Enable Event-triggered Snapshot under the snapshot
parameters. See “Snapshot parameters” on page 46
for further
information.
Trigger Channel
Triggers the recording to start in the camera.
Trigger Alarm Output
Trigger external alarm outputs when an event occurs. Check
“Select All” or each individual alarm output.
Note: This option is only supported by cameras that support
alarm output.
7. Click Save to save changes.
Audio exception detection
Audio exception detection detects sounds that are above a selected threshold.