EasyManua.ls Logo

Interlogix TVB-5501 - Accessing the SD Card; SD Card Installation and Access; Mounting the Bullet Camera

Interlogix TVB-5501
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 Installation Guide
Equipment Disposal
sheet
Battery Disposal Sheet
Caution: Use direct plug-in UL listed power supplies marked
Class 2/CE certified or LPS (limited power source) of the
required output rating as listed on the unit.
Caution: Risk of explosion if the battery is replaced by an
incorrect type. Dispose of used batteries according to the
instructions.
Cable requirements
For proper operation, adhere to the following cable and power
requirements for the cameras. Category 5 cabling or better is
recommended. All network cabling must be installed according
to applicable codes and regulations. Table 1 lists the
requirements for the cables that connect to the camera.
Table 1: Recommended power cable requirements
IP bullet
camera: 12 VDC power wires or PoE (802.3af)
IP turret
camera: 12 VDC power wires or PoE (802.3af)
IP dome
camera: 12 VDC power wires or PoE (802.3af)

Related product manuals