Installation Guide 15
3. Loosen the large nut at the base of the mounting bracket
to adjust the camera’s viewing angle.
Pan direction: 0 to 360° adjustable
Tilt direction: 0 to 90° adjustable
Rotate direction: 0 to 360° adjustable
4. Adjust the lens to the desired surveillance angle. Tighten
the adjustable nuts to complete the installation.
Mounting the turret camera
To mount the turret camera on a surface:
1. Place the drill template (supplied) on the surface where
the camera is to be mounted. Drill mounting holes in the
surface using the holes labeled number “1” on the drill
template.
If you would like to route the cable harness through the
mounting surface, cut a cable access hole in the
mounting surface, referencing the letter “A” on the drill
template. Skip this step if you want to route the cables on
the surface.
To Next Page
Loading...
