Intermec CK3 User Manual

Chapter 4 — Troubleshooting and Maintaining the CK3
CK3 Mobile Computer User’s Manual 79
To clean boot the CK3
1 Press and hold for about 2 seconds to suspend the CK3.
2 Remove the battery.
3 Use the stylus to press the reset button in the battery
compartment of the CK3.
4 Replace the battery.
5 Press and hold both and the PTT button.
6 Continue to hold and PTT until the “Clean boot the system?”
prompt appears on screen.
7 Release the two buttons, read the message, and press the
appropriate button to either proceed with the clean boot or cancel
the clean boot.
Reset button
Note: You can also clean boot your CK3 from the SmartSystems
console: right-click the CK3 and select Intermec Power Tools >
Clean Boot Device.

Intermec CK3 Specifications

General

RAM capacity	128 MB
Certification	GS, EN55022 Class B, ICES-003 Class B, EN 300.328, FCC Part 15.247, RSS-210, EMC, FCC Part 15, R&TTE, RoHS, WEEE, cULus
Product color	Gray
Internal memory	512 MB
Built-in display	Yes
Housing material	-
Display resolution	240 x 320 pixels
Display technology	TFT
Processor frequency	520 MHz
Bluetooth version	2.0+EDR
USB 2.0 ports quantity	2
Connectivity technology	Wired & Wireless
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Operating system installed	Windows Mobile 6
Type	Handheld bar code reader
Scanner type	1D/2D
Power source type	Battery
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	36 mm
Width	84 mm
Height	217 mm
Weight	453 g