Intermec CK30

12 CK30 Handheld Computer User’s Manual Addendum
5 For Authentication, choose LEAP and then press Enter.
6 For Association, choose Open or Network EAP and then
press Enter.
7 For Encryption, choose WEP and then press Enter.
8 Select User name, type your user name, and then press Enter.
9 Select Password prompt, choose Enter password now, and
then press Enter.
Note: You can use Prompt for password to troubleshoot
your connection to the network if you have problems.
10 Select User Password, type a user password, and then press
Enter.
11 Exit the Configuration Utility.
Configuring Static WEP Security
The CK30 uses the Wired Equivalent Privacy (WEP) protocol
to add security to wireless local area networks (WLANs) based
on the 802.11b standard.
To use WEP security, you need:
• A CK30 handheld computer with an 802.11b/g radio.
• An access point with an 802.11b/g radio.
To enable WEP security on the CK30
1 Make sure you have selected Funk as your security choice.
2 Make sure you have configured the communications and
radio parameters on your CK30.
3 Press C and then B to open the System Main Menu.
4 Choose Configuration Utility > Communications > 802.11
Radio > Profile Settings.
5 For Association, choose Open and then press Enter.
6 For Encryption, choose WEP and then press Enter.