18 CK30 Handheld Computer User’s Manual Addendum
Understanding Radio Power Management Settings
There are now only two choices for radio power management
settings on the CK30. These radio power management settings
apply to Microsoft security. Use this table to understand the new
power management settings.
New Settings Description
Disabled (CAM) Specifies continuous access mode (CAM) and
is the default.
Enabled (FAST PSP) Specifies a fast power saving mode that
provides the best combination of performance
and power usage.
Using Energy Saving Mode With Your 1551E or 1553
Scanner
Use Energy Saving mode with your 1551E or 1553 scanner to
save battery power on your CK30. When you use Energy Saving
mode, the scanner is active while you are pressing the trigger and
goes into Standby mode after a good read. With Energy Saving
mode enabled, the current consumption drops to zero during
standby. Full energy is restored when you scan the next label.
To use Energy Saving mode, you need:
• An energy saver cable. On a 10-pin scanner port, cable
P/N 3-606034-02 is required.
• Firmware version 2.13 or later on the scanner.
To Next Page
Loading...
