CK30 Handheld Computer User’s Manual Addendum 9
b For Validate Server Certificate, choose Enabled and press
Enter.
c You must enter a User Name and Subject Name. You can
also enter a Server Common Name if you want to increase
your level of security.
8 Exit the Configuration Utility.
To enable WPA-PSK security on your CK30
1 Make sure you have selected Funk as your security choice.
2 Make sure you have configured the communications and
radio parameters on your CK30.
3 Press C and then B to open the System Main Menu.
4 Choose Configuration Utility > Communications > 802.11
Radio > Profile Settings.
5 For Authentication, choose None and press Enter.
6 For Pre-Shared Key, enter the pre-shared key or the pass
phrase.
The pre-shared key must be a value of 32 Hex pairs. The pre-
shared key must be preceded by 0x. The value must match
the key value on the access point. The pass phrase must be
from 8 to 63 characters.
7 Exit the Configuration Utility.
Configuring 802.1x Security
802.1x security provides centralized user authentication using an
authentication server, authenticators (access points), and
supplicants. These components communicate using an EAP
authentication type, such as TLS (Transport Layer Security) or
PEAP (Protected Extensible Authentication Protocol). 802.1x
security provides data encryption using dynamic WEP key
management.
To use 802.1x security, you need:
• An authentication server
To Next Page
Loading...
