Chapter 1 — About the Computer Features
CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manual 9
Change the Battery
The CN50 resets when you remove the battery.
1 Save your files and close any open applications.
2 Shut down the CN50 by tapping Start > Shut Down. For more
information, see “Warm Boot the Computer” on page 105.
3 If necessary, disconnect the handstrap from the top of the CN50.
4 Push forward on the battery release tab until the battery releases,
and then lift it away from the CN50.
5 Insert the bottom of a fully charged battery into the CN50, and
press down on the top until it clicks into place.
6 If necessary, replace the handstrap.
About the Battery Status
Use the battery icon on the Title bar to see the power status of your
battery.
To Next Page
Loading...
