Chapter 4 — Use the Imager
44 CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manual
Read Bar Codes
1 Press ^ to turn on the CN50.
2 Point the scanner window at the bar code label, and hold the CN50
steady a few inches from the label.
3 Press the Scan button. The laser pointer and illumination beam
and frame appear.
4 Use the laser pointer as a guide and aim toward the middle of the
bar code. Make sure that the illumination frame covers the bar code
you are trying to decode.
When the CN50 successfully reads a bar code label, you hear a high
beep, and the Good Read LED turns on briefly.
5 Release the Scan button.
To develop an application you can use to configure the imager, use the
Data Collection Resource Kit. The resource kit is part of the Intermec
Developer Library (IDL) and can be downloaded from the Intermec
website at www.intermec.com/idl.
To Next Page
Loading...
