Chapter 7 — Configure the Computer
68 CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manual
Enable the Wi-Fi Radio With ScanNGo Bar Codes
Use the ScanNGo bar code to enable the Wi-Fi radio and set the Funk
security to its default settings.
To enable the Wi-Fi radio and set all communication settings to their
default values, scan the following ScanNGo bar code.
• Enable Wi-Fi, set Funk defaults (Wi-Fi, WWAN Radio if applicable
)
The ScanNGo application starts, enables the radio, and configures the
default security settings. If you want to change the security settings
from their default values, see “About Wireless Security” on page 76.
Configure Ethernet Communications
You connect your CN50 to your Ethernet network with an Ethernet
cable and an AD24 Ethernet multidock or AD27 single dock with
Ethernet adapter.
1 Connect your CN50 to an Ethernet network with an AD24.
Ethernet communications is automatically enabled on your CN50.
2 Make sure that your CN50 is communicating with the network.
You should see the network connection icon ( ) in the navigation
bar.
To Next Page
Loading...
