Intermec EasyCoder PD4 Installation Instructions

4 EasyCoder PD4 Cutter Installation Instructions
Chapter 1 — Installation
Cable clips
Cutter cable
Cutter
connector
5 Plug in the cable from the cutter into the rear one of the two connectors in
the center section and fasten the cable to the bottom plate using the two
cable clips included in the kit.
6 Attach the cutter cover onto the cutter mechanism by fi rst connecting the
hooks on the back side of the cover over the cutter mechanism and then
locking the cover with the screw at the bottom.

Intermec EasyCoder PD4 Specifications

General

Brand	Intermec
Model	EasyCoder PD4
Category	Label Maker
Language	English