EasyCoder PD4 Cutter Installation Instructions 5
Chapter 1 — Installation
7 Install the media as described in the Loading Media chapter, section
“Tear-off (Straight-through)” of the EasyCoder PD4 User's Guide. Rec-
ommended label/paper length is at least 30 mm (1.18 in).
Note: Make sure that the printer is set to use the cutter, either
in the Setup Mode (see Chapter 7) or using an O command,
see ESim v5.xx for EasyCoder PD4, Programmer’s Reference
Manual. e label taken sensor cannot be used with the cutter.
6 If needed, fi t the tray to the front of the cutter.
To Next Page
Loading...
