Intermec IF30 User Guide

GPIO Terminal Block User’s Guide 7
About the GPIO Terminal Block
Use the GPIO terminal block (P/N 203-726-002) to connect industrial
controls such as motion sensors or lights to Intermec RFID readers.
GPIO Terminal Block
What You Need
You connect the terminal block to the reader with a GPIO cable:
• For IF5, IF30, and IF61, use Intermec P/N 236-057-001.
• For IV7, use Intermec P/N 236-089-001. This cable also connects
the IV7 to a host PC.
You supply your own cables or wiring for your industrial controls.
For more information on connecting industrial controls to the
terminal block, see “Connecting To the IF5, IF30, and IF61
Readers” on page 12.
Note: Using the terminal block with the IV7 Vehicle-Mount Reader
requires special considerations. For more information, see
“Connecting To the IV7 Vehicle-Mount Reader” on page 23.

Intermec IF30 Specifications

General

Brand	Intermec
Model	IF30
Category	Barcode Reader
Language	English