UDM108-01 17 RSA2024-TB/2”
Air Connection
The regulator has a male "quick disconnect" adaptor. Connect clean dry compressed air to this
adapter. The RSA2024-TB requires a minimum of 3 C.F.M. at 75 psi maximum.
To regulate the air pressure, pull on the
green knob located on the side of the
machine. Turn the knob clockwise for
more pressure and counter clockwise for
less. When the air pressure is at 75 psi,
push back down on the button until a
"click" is felt. The threading size is 3/8
NPT.
Pneumatic Adjustment
The main air filter/regulator controls the air pressure going inside the machine. It also controls
the air pressure inside the cylinders that rise the Top Belt Drive Assembly and open the infeed
guides. The recommended pressure setting for the main air filter/regulator is between 60
and 70 PSI.
The Infeed Guide Pressure is controlled with the pressure regulator located at the infeed end of
the machine, under the left hand Side Cover (Item 24 on the Bottom Belt Drive Structural
drawing). By increasing the air pressure, you increase the centring force of the guides on the
box. The recommended pressure setting for the Infeed Guide regulator is between 30 and
40 PSI.
The weight of the Top Belt Drive Assembly on the box is controlled by the High Flow Pressure
Control located at the discharge end of the machine, under the left hand Side Cover. This
controls the air pressure at the bottom of the cylinder and counterbalance for the weight of the
Top Belt Drive Assembly. Therefore, to reduce the weight applied on the top of the box, you
have to increase the air pressure. . The recommended pressure setting for the High Flow
Pressure Control is between 35 and 45 PSI.
Figure 11
To Next Page
