UDM108-01 18 RSA2024-TB/2”
Operating Instructions
Once the HSD
®
2000 Tape Heads, (both bottom and top) have been loaded with tape and
threaded the machine is ready to process RCS cartons. The following instructions are presented
in the order recommended for processing cartons successfully through the RSA 2024-TB
Carton Sealing machine.
1- Activate air Supply (3 C.F.M. at 80 P.S.I.).
2- Switch the machine on with start push button.
3- Place carton with flaps held in closed position on the Infeed Table up to sensor #1.(Item
45 or 49 on the “Infeed Table W/ Guide” drawing)) Sensor will detect carton and the
Infeed Guides will center the carton.
Warning:
Ensure that the operator’s hands are away from the contact area between the Infeed
Guides and the carton.
4- Push carton with flaps held in closed position against the Front Sensing Paddle at the
front of the Top Belt Drive Assembly. This will raise the Top Belt Drive Assembly. Push
the rear of the carton until it is between the top and bottom drive belts.
WARNING!!
Ensure That The Operator’s Hands Are Away From The Moving Belts Of The Top And
Bottom Drive Assemblies
5- When the carton exits the Carton Sealer, the Top Belt Drive Assembly will go down to
his initial position.
6- The Carton Sealer is now ready to process the next carton..
To Next Page
