UDM108-01 20 RSA2024-TB/2”
The Top Belt
Drive Assembly
raises too slowly.
1- The inlet pressure is too low.
2- The moving parts are rubbing
on something.
1- Adjust the inlet pressure on the
main regulator to 80 psi and
make sure that the pressure
doesn't fall below 70 psi while
it is operating.
2- Inspect the Top Belt Drive
Assembly to make sure that
noting interferes with them.
The Top Belt
Drive Assembly
does not rise
when the carton
pushes the Front
Sensor Plate.
1- The Proxy Sensor behind the
sensor plate is too far from
the Front Sensor Plate.
1- Remove the Front Sensor Plate
and adjust the position of the
Proxy Sensor by moving it by
1/16”, then replace the Front
Sensor Plate and verify proper
operation. Make sure that the
sensor does not touch the Front
Sensor Plate.
The cartons are
not taped
properly.
1- The tape head is not adjusted
correctly
1- Refer to the tape head manual.
To Next Page
