UM094TW / UM594TW UDM094-04
51
M
ACHINE
M
AINTENANCE
&
A
DJUSTMENT
Drive Belt Adjustment
Using a 4mm Allen key, remove screws (2) and remove
drive base cover.
Using appropriate Allen key and wrench, tighten
belt tensioning bolts.
Be sure to adjust upper and lower tensioning bolts
equally.
Proper belt tension is achieved when a 5 pound pull
force is used to create a 1” gap as shown in the Middle
of the drive base.
Intertape S/B drive idler pulleys are engineered to self-
track to center.
After tensioning, if the belts do not track on center,
contact maintenance or your IPG Distributor.
Using a 4mm Allen key, replace drive base cover as
shown.
1” Midspan
To Next Page
Loading...