Interphone U-COM 2 - 7. BLUETOOTH INTERCOM; 7.1 Intercom pairing

10
7. BLUETOOTH
®
INTERCOM
7.1 Intercom pairing
U-COM 2 can be paired with up to 3 other UCOM units (or Sena units), as
shown in the following picture.
A
B C D
The pairing is only necessary the rst time, then the control units will
automatically recognize each other.
1. Press and hold the center button (intercom) on boht units A and B for 5
seconds, until you hear the voice prompt “intercom pairing”. The light
ashing red indicates the device is now visible.
5 sec
5 sec
A
B
A
B
After few seconds the units will be paired and they will start the intercom
communication. The light on both units will ash blue twice.
2. Repeat the previous step again, pressing the center button (intercom)
on the two units A and C for 5 seconds until you hear the voice prompt
“Intercom pairing”.
3. Repeat the procedure again, pressing the centre button (intercom) of
the two units A and D for 5 seconds until you hear the voice prompt
“Intercom pairing”.
5 sec
5 sec
A
C
A
C
5 sec
5 sec
A
D
A
D