12
Repeat the same command to disconnect intercom unit from the
phonecall conference.
To disconnect the mobile phone call during a conference phone call, press
and hold the Center Button for 2 seconds.
Note: When you have an incoming intercom call during a mobile phone call,
you will hear high tone double beeps.
7.6 Old Interphone Series
It is possible to pair previous Interphone series devices by pressing, with the
unit on, the INTERCOM and TELEPHONE buttons for 5 seconds. Then start
pairing mode on the second unit, usually pressing the power button (with
the control unit o) until the led ashes red/blue.
6 sec
5 sec
Bluetooth
Mesh
Interphone U-Com 16 (Utente) Aggiungi utente
Aggiungi utenteAggiungi utente
Fine intercom
Setup
Bluetooth
®
Intercom - other pairings
Other Interphone series pairing (to be done with unit OFF)
Anycom pairing for other brands (except Sena)
Anycom
pairing
Interphone
pairing
Intercom
pairing
Con guration
menu
Mobile phone
pairing
7.7 Anycom
Anycom feature allows intercom conversations with other intercom brands.
It is possible to pair the intercom with only one non-Interphone device at a
time. The intercom distance depends on the performance of the connected
Bluetooth
®
intercom. When a not-Interphone device is paired with the
Interphone device, if another Bluetooth
®
device is paired via the second
mobile phone pairing, it will be disconnected.
x 3
10 sec
?
Bluetooth
Mesh
Interphone U-Com 16 (Utente) Aggiungi utente
Aggiungi utenteAggiungi utente
Fine intercom
Setup
Bluetooth
®
Intercom - other pairings
Other Interphone series pairing (to be done with unit OFF)
Anycom pairing for other brands (except Sena)
Anycom
pairing
Intercom
pairing
Con guration
menu
Mobile phone
pairing
1. With U-COM 2 on, enter the conguration menu by pressing the central
button for 10 seconds. Do not to release the button before the led turns
blue.
2. Press the PHONE button 3 times to activate the ANYCOM pairing mode.
3. Set the not-Interphone intercom to mode Phone pairing.
To Next Page
Loading...
