Quick-Start
Unless otherwise specified, quick-start instructions apply to all models.
See Installation and Startup for additional information.
1
Fill reservoir with fluid
2
Connect all electrical power cords
and control cables
3
Place Power Switch / Circuit
Breaker in ON position
Maximum: 1 in. / 2.54 cm
below underside of top
deck
Minimum: 4.5 in. / 11.5 cm
below top deck
Heating only models
IEC power cord
from Controller to
Refrigeration
Power Module
Refrigeration
control cable
Refrigerating / heating
models
Heating only models
Refrigerating / heating
models
110-512 PSC/EN
12
To Next Page
Loading...