EasyManuals Logo

Intex CS20110 User Manual

Intex CS20110
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background image
PRODUCT SPECIFICATIONS
English
The sand filter removes suspended particles from your pool. Pool chemistry
is a specialized area and you should consult your local pool
service specialist for details.
Power:
Amperage:
Wattage:
Ideal Salt Level:
110 - 120 Volt AC
Saltwater System - 1.1 A; Filter Pump - 6 A
Saltwater System - 120 W; Filter Pump - 650 W
3000 ppm (parts per million)
Maximum Sanitizer Output/hour: 12 grams/hour
Copper Ionizer Output Current: 175 mA
Maximum working pressure:
Effective filtering area:
Maximum Flow Rate:
Recommended filtering media:
(Not included)
3.5 bar (50 psi)
0.13 m
2
(1.44 ft
2
)
10030 liters/hour (2650 gallons/hour)
Use only No. 20 silica sand. Particle size
range 0.45 to 0.85 mm (0.018 to 0.033
inches). Uniformity Coefficient less than 1.75.
Recommended filtering media quantity: 45 Kg (100 Lbs)
Limited Warranty:
2 Years (see “Limited Warranty”)
SETUP INSTRUCTIONS
TOOLS REQUIRED: One (1) Phillips screwdriver
One (1) pair of pliers or a small adjustable wrench
Pump location and mounting:
The system must be installed on a solid level and vibration-free base.
Provide a location protected from the weather, moisture, flooding and
freezing temperature.
Provide adequate access, space and lighting for routine maintenance.
Pump motor requires free circulation of air for cooling. Do not install
the pump in a damp or non-ventilated location.
A team of 2 or more adults is recommended for setting up this product.
Motor pre-filtering assembly setup:
1. Remove the sand filter and its accessories
from the packaging carefully and inspect for
any visible damage. If parts are damaged
contact your local service center listed at the
back of this owner’s manual.
2. In a counter-clockwise motion unscrew the leaf
trap cover (17) from the pre-filter housing. Take
out the basket (19) and filter housing nut (20)
(see drawing 10).
3. Connect the pre-filter housing to the motor
water inlet. Note: Align the connector in the
pre-filter housing with the water inlet on the
motor (see drawing 11).
SAVE THESE INSTRUCTIONS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex CS20110 and is the answer not in the manual?

Intex CS20110 Specifications

General IconGeneral
BrandIntex
ModelCS20110
CategoryWater Pump
LanguageEnglish

Related product manuals