LED PANEL
TROUBLESHOOTING GUIDE (continued)
CODE
PROBLEM
SOLUTION
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Circulation line is blocked.
• If your unit has plunger valves, ensure
that they are open.
- Clear your basket and cell of debris and dirt. See “Maintenance”
- Depress the 6-way valve, release all
2. Incorrect inlet and outlet hose
trapped air in the circulation line.
• Check the direction of the inlet and the
direction.
3. Scale on the flow sensor.
outlet hose. Reverse the hoses if
necessary. See “Set Up Instructions”.
• Clean the flow sensor, paying special
4. Flow sensor cord is loose.
attention to the hinge. See
“Maintenance”.
• Plug the flow sensor firmly into the flow
5. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
sensor receptacle.
• Contact Intex Service Center.
• Remove the electrolytic cell for
inspection. Clean it if necessary.
See “Maintenance”.
• Add salt. See “Salt & Pool Water
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
Volumes”.
• Ensure that the cell cord is plugged
firmly into the cell housing receptacle.
• Contact Intex Service Center. Replace
1. High salt level.
the cell if needed.
• Partially drain the pool and refill it with
1. Display and all lights are off - the
system does not power up.
fresh water. See “Salt & Pool Water
Volumes”.
•
House
hold voltage is too high or too low
(+ 20%). Check the voltage is within the
Range stated on the device housing.
- Contact Intex Service Centre
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
