Why is my Intex ECO15220 Swimming Pool Pump filter motor not starting?
First, ensure the line cord is plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. Try resetting the circuit breaker; if it repeatedly trips, your electrical system may have a defect, so turn off the breaker and call an electrician. Also, let the motor cool down before restarting.
What to do if my Intex Swimming Pool Pump filter doesn’t pump water or the flow is very slow?
If your filter isn't pumping water effectively, start by clearing any obstructions in the intake hose by discharging it inside the pool wall. Ensure that the hose nuts are tightened, check the hoses for damage, and verify the pool water level. Clean the pre-filtering basket more often and backwash the filter. Also, install the nozzle at the upper position of the pool inlet, and the strainer at the lower position of the pool outlet. If necessary, remove about 1” of sand. Finally, remove any pool vacuuming device attached to the system line.
What to do if my Intex ECO15220 filter doesn’t clean the pool?
To improve your filter's cleaning performance, ensure the valve is set to the “FILTER” position and operate the filter for longer periods. Clean the basket. You can also use an Intex pool vacuum to clean the bottom of the pool.
Why is the 6-way valve/cover leaking on my Intex ECO15220?
If the 6-way valve/cover is leaking, remove the cover and make sure the o-ring is in place. Clean the sand tank o-ring with garden hose water and tighten the clamp with the wrench supplied.
What to do if there are white flakes in the water of my Intex Swimming Pool?
If you notice white flakes in the water, drain about 20 to 25% of the pool water and add fresh water to decrease the calcium hardness. Inspect the electrolytic cell for scale buildup and clean it if necessary.
How to fix a hose leaking on my Intex ECO15220 Swimming Pool Pump?
To fix a leaking hose, try tightening or reinstalling the hose nut. Also, make sure the o-ring or L-shape o-ring is in place and not damaged.
What to do if sand is flowing back into the pool from my Intex Swimming Pool Pump?
If sand is flowing back into the pool, ensure you are using only No. 20 silica sand with a particle size range of 0.45 to 0.85 mm (0.018 to 0.033 inches) and a Uniformity Coefficient less than 1.75. If the issue persists, consider changing the sand.
How to fix no LED display on Intex ECO15220?
To fix a missing LED display, ensure the cell cord is firmly plugged into the cell housing receptacle and reset the RCD.
What to do if the pressure gauge doesn’t work on my Intex Swimming Pool Pump?
If the pressure gauge isn’t working, clear any obstructions in the intake by unscrewing it from the 6-way valve.
Details connecting the pre-filter housing and basket to the pump motor.
Explains the different settings of the 6-way valve and their purposes.
How to program operating times, use boost, and lock controls.
General| Brand | Intex |
|---|---|
| Model | ECO15220 |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page