257
PO
SAVE THESE INSTRUCTIONS
English
(257PO) MODEL 601 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 04/22/2016
Page 7
POOL CARE AND CHEMICALS
• Allpoolsrequirecaretokeepthewaterclearandhygienicallyclean.Withproperchemical
control, your filter will help attain this objective. Consult your pool supply dealer for
instructions regarding the proper use of chlorine, algaecide and other chemical agents
required for sparkling clear water.
• Keeppoolchemicalsawayfromchildren.
• Donotreplenishchemicalsinpoolwhilepoolisoccupied.Skinoreyeirritationscouldoccur.
• DailypHcheckingandchemicaltreatmentofthewaterisveryimportantandcannotbe
overemphasized. Chlorine, algaecide and maintenance of proper pH levels are required
when filling the pool as well as during the season. Consult your local swimming pool supply
store for instructions.
• Theseason'sfirstfillingofthepoolmayhavebrackishwaterrequiringextrawateradditives
and extra filter changes. Do not allow swimming in pool until the pH level is balanced.
Consult your local swimming pool supply store for instructions.
• Keepsparefiltercartridgesonhand.Replacecartridgeseverytwoweeks.
• Chlorinatedwatermaydamagelawns,gardensorshrubberyaschildrenplayinthepooland
splash water outside the pool. Lawn areas underneath the pool liner will be destroyed. Note
that some types of grass may grow through the liner.
• Filterruntimedependsonpoolsize,weatherandusagelevel.Experimentwithvariousrun
times so as to produce clean clear water.
CAUTION
Concentrated chlorine solutions may damage the pool liner. Always follow the
chemical manufacturer’s directions, and the health and hazard warnings.
1.
Before emptying your pool for long term storage, or relocation, be sure the water is directed
towards an acceptable drain water receptacle away from the house. Check local regulations
for specific directions regarding disposal of swimming pool water.
2
. Now, drain the pool.
3.
When the pool is empty, disconnect all pool hoses
(8)
from the pool and filter pump, simply
reverse the set up instructions.
4.
Remove the filter cartridge as shown in the Filter Cartridge Cleaning section, steps 2 thru 4.
5.
Remove the nozzle and strainer unions from the pool wall. Place the wall plugs into the hose
connections. Loosen clamps
(7)
securing the strainer connectors
(9)
before removal.
6.
Drain water from the filter pump housing.
7.
Leave filter pump pieces and hoses outside to thoroughly air dry.
8.
Depending on the cartridge
(5)
usage, a new cartridge may be needed for next season,
keep a spare available.
9.
Cover the seal
(4)
, air release valve O-ring
(2)
and hose seals
(6)
with petroleum jelly to
preserve its resilience during storage.
10.
Store the unit and accessories in a dry place.Thestorage'stemperatureshouldbe
controlled, between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit
(40 degrees Celsius) storage location.
11.
The original packing can be used for storage.
LONG TERM STORAGE