Intex PureSpa SSP-10 User Manual

192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 10
SET UP (continued)
Spa Control Unit Installation
1. Press the button located on top of the control base andremovethebackcover(see drawing 9)
2. Connectthespacontrolunittothespatub(see drawing 10). Hand-tighten the connectors securely.
 Donotusetoolstotighten.
3. Reinstallthebackcover (2) to the spa control base (see drawing 11). Backcovermustbeinstalled 
 beforeusingtheSPA.
CAUTION: Donotsit,lean,coverorplaceanyobjectsoverthespacontrolunit.
4. Attachthetwoltercartridgehousingassembliestothetwooutlet 
 gridsontheinsideofthespa(lowerposition,marked“C”).
ATTENTION! Inordertocomplywiththerequirementsofthe
 VirginiaGrahameBakerAct,suctionoutletscannotbecovered
 whilethespaisinuse.TheActwasintendedtoaddresshigh
 suction/volumecirculationsystemsbutdoesnotexcludelow
 volumesystemsasusedonthisspa.Accordingly,removethelter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage (see drawing 12).
 Re-attachthemafterusageforwaterltrationandcleaning.
5. Beforellingwithwaterensurethebottomdrainvalvecapsare 
securely closed on the inside and outside.
6. FillthespatubwithfreshwatertoalevelbetweenMINandMAX 
 markedontheinsideofthespawall.Donotoverllthespa.
. WARNING: Neverpourwaterwithatemperaturehigherthan104°F(40°C)intothespadirectly.Itis
 recommendedtollthespatubwithlukewarmwaterforquickheatingandenergysaving.
7. Placethespacoverandspaairbladder(pre-installedinspacover)overthespatub,andmakesurethe
 spacoverbucklesarelockedusingthekeyprovidedafterpullingthebuckledstrapstight.
IMPORTANT:Inspectthespacoverregularlyforleak,prematurewearandtearordeterioration.Never
 useadamagedspacover.
8. Turnontheheateronthespacontrolunitsee“SpaControlUnitPanel”operatinginstructionssection. 
 Theheatingsystemiscapableofincreasingthewatertemperaturebyapproximately2-3ºF(1-1.5ºC)
per hour.
11
2
10
A
B
C
B
C
A
9
Press
A
B
C
B
C
A
12
C

Intex PureSpa SSP-10 Specifications

General

Brand	Intex
Model	PureSpa SSP-10
Category	Hot Tub
Language	English