Intuitive DAVINCI XP - da Vinci SP Port Accessories Guide; Port Accessories Introduction

da Vinci SP Instruments and Accessories
da Vinci SP Port Accessories
63
DRAFT/PRE-RELEASE/CONFIDENTIAL
12/5/19
9 da Vinci SP Port Accessories
9.1 Introduction
This section contains instructions for use specific to the da Vinci SP® port accessories
(da Vinci SP Cannula, da Vinci SP Obturator, and EntryGuide™ Kit) used with the
da Vinci SP System.
Note: Reusable SP Cannulas and obturators are shipped non-sterile unless
otherwise indicated in the device’s labeling. Clean and sterilize before use.
Intended Use
For intended use of the port accessories, see Appendix D: Intended Use Statements.
Cautions for Single-Use Items
CAUTION: DO NOT RE-STERILIZE. DO NOT RE-USE.
Reprocessing and/or reuse of products intended for single use only may result in
degraded instrument performance or loss of functionality, and in exposure to viral,
bacterial, fungal, or prionic pathogens.
CAUTION: Do not use if package is damaged.
CAUTION: A breach in the sterile packaging of the device indicates possible
contamination. Do not use the device if the packaging is not intact.
9.2 Device Description
Compatibility Information
Table 9-1 shows compatible products used with the da Vinci SP System.
Table 9-1 da Vinci SP Port Accessory Compatibility
SP Cannula PN SP Obturator PN EntryGuide Kit PN
SP Cannula, Circular,
25 mm x 100 mm
(430036)
SP Obturator, Circular,
25 mm x 100 mm
(430016)
EntryGuide Kit C.6.6.6, 25 mm x 100 mm
(includes EntryGuide Cannula Insert and
EntryGuide Cannula Seal)
(430022)