Invacare 6417 User Manual

Part No 1143201 1 Deluxe Overbed Table
For more information regarding Invacare products, parts, and services, please visit www.invacare.com
Deluxe Overbed Table
Model Nos. 6417, 6418
DEALER:TheseinstructionsMUSTbegiventotheuserofthisproduct.
NOTE:CheckALLpartsforshippingdamage.Ifshippingdamageisnoted,DONOTuse.ContactCarrier/Dealerforfurther
instruction.
Safety Summary
Toensurethesafeandproperinstallationofthedeluxeoverbedtable,theseinstructionsMUSTbefollowed:
 WARNING
DO NOT use this product or any available optional equipment without first completely reading
and understanding these instructions and any additional instructional material such as owner’s
manuals, service manuals or instruction sheets supplied with this product or optional equipment.
If you are unable to understand the warnings, cautions or instructions, contact a healthcare
professional, dealer or technical personnel before attempting to use this equipment - otherwise,
injury or damage may occur.
ALWAYS check the overbed table for proper tightness before using.
The deluxe overbed table has a weight limitation of 25 lbs.
 ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction with
Invacare accessories. Accessories designed by other manufacturers have not been tested by
Invacare and are not recommended for use with Invacare products.
 INSTALLATION WARNING
After any adjustments, repair or service and before use, make sure that all attaching component
parts are secure.
Assembling/Disassembling
Model 6417
NOTE:Forthisprocedure,refertoFIGURE 1onpage2.
1. Placetabletoponfloorwithmountingholesfacingup.
2. Securethemasttothetabletopwithsixmounting
screws.Tightensecurely.
3. Securethebasetothemastwiththetwobolts,washers,
andinserts.Tightensecurely.
4. Installthefourcastersinto
thefourholesprovidedin
thebase.
5. Placetheoverbedtabletotheuprightposition.
6. Todisassemble,reverseSTEPS1‐5.
Model 6418
NOTE:Forthisprocedure,refertoFIGURE 1onpage2.
1. Placethetilttabletoponthefloorwithsupporting
bracketfacingup.
2. Securethemasttothe supportingbracketwiththebolt,
washer,andnut.Tightensecurely.
3. Securethebasetothemastwiththetwobolts,washers,
andinserts.Tighten
securely.
4. Installthefourcastersintothefourholesprovidedin
thebase.
5. Placetheoverbedtabletotheuprightposition.
6. Todisassemble,reverseSTEPS1‐5
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS

Invacare 6417 Specifications

General

Base Material	Steel
Weight Capacity	50 lbs
Product Type	Overbed Table
Tabletop Material	Laminate
Material	Steel

Summary

Safety Summary

Assembling and Disassembling

Model 6417 Assembly/Disassembly

Steps for assembling and disassembling Model 6417, including securing parts.

Model 6418 Assembly/Disassembly

Steps for assembling and disassembling Model 6418, including securing parts.

Operating the Overbed Table

Adjusting Table Height

Procedure for adjusting the table top height using the height adjustment lever.

Adjusting Table Angle

Procedure for tilting the table top to a desired angle on Model 6418.

Transporting

Limited Warranty