Invacare Carroll CS5 User Manual (English)

Questions and Answers:

R
Rachel MichaelAug 8, 2025
What to do if the actuator is not working on Invacare Carroll CS5 Medical Equipment?
- S
  sarahthompsonAug 8, 2025
  If the actuator on your Invacare Medical Equipment isn't working, there are several things you can check: * **System Fault:** Try resetting the system by holding the bed up and bed down buttons on the pendant for 5+ seconds. The bed will beep and stop when the reset is complete. Then, press the bed up button. If it beeps, the actuators are out of sync; raise the bed to the highest position to synchronize them. * **HI/LO Lock-out:** Make sure the lockout dial is in the unlocked position (horizontal) or the switch is set to OFF. * **Attendant Control Pad (ACP):** Ensure the lockout LED on the ACP is OFF by toggling the individual function lockout. * **Wire Connections:** Check for and connect any loose cable couplings or power supplies.
J
Juan HerringAug 19, 2025
Why my Invacare Carroll CS5 Medical Equipment bed does not stay in place?
- K
  Kim CunninghamSep 12, 2025
  If your Invacare Medical Equipment bed is not staying in place, here's what you should check: 1. **Floor Lock:** Ensure the floor lock is fully engaged. The green plunger should not be visible. 2. **Floor Condition:** Clean the surrounding floor area to remove any loose material or debris that might be reducing friction between the floor lock foot bumper and the floor.
R
Rebecca BeckAug 28, 2025
How to level Invacare Carroll CS5 Medical Equipment bed?
- D
  Donna MontgomeryAug 28, 2025
  To address a bed that is not level, raise the Invacare Medical Equipment bed to its highest position or lower it to its lowest position.