EasyManua.ls Logo

Invacare Carroll CS7 - User Manual

Invacare Carroll CS7
65 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
+PXCECTGs %CTTQNN %5 5GTKGUŗ
%5 %5 %5 %5 %5(:
GP $GFU
7UGT /CPWCN
6JKU OCPWCN /756 DG IKXGP VQ VJG WUGT QH VJG RTQFWEV
$'(14' WUKPI VJKU RTQFWEV TGCF VJKU OCPWCN CPF UCXG HQT HWVWTG TGHGTGPEG
+PXCECTG %QPVKPWKPI %CTG +PE # UWDUKFKCT[ QH
+PXCECTG %QTRQTCVKQP
+PXCECTG %QPVKPWKPI %CTG +PE
YYYKPXCECTGEEEQO
75# CPF %CPCFC
&GUKIPGF D[ +PXCECTG %QTRQTCVKQP +PXCECTG #WUVTCNKC 2V[ .VF
1PG +PXCECTG 9C[ .GPVQP 2NCEG
'N[TKC 1JKQ 75# 0QTVJ 4QEMU 059 
ņ
/CPWHCEVWTGF KP /GZKEQ HQT +PXCECTG
%QTRQTCVKQP
5[FPG[ #WUVTCNKC
6GN ņņ ņņņņ
0` 
*1153410Na00*
/CMKPI .KHGʼnU 'ZRGTKGPEGU 2QUUKDNGŗ
02/04/15
This document was released at Pre-Release 00.

Table of Contents

Questions and Answers

  • C
    Charles Matthews MDAug 8, 2025
    What to do if the actuator is not working on Invacare Medical Equipment?
    • B
      Brittney CaseAug 8, 2025
      If the actuator on your Invacare Medical Equipment isn't working, there are several things you can check: * **System Fault:** Try resetting the system by holding the bed up and bed down buttons on the pendant for 5+ seconds. The bed will beep and stop when the reset is complete. Then, press the bed up button. If it beeps, the actuators are out of sync; raise the bed to the highest position to synchronize them. * **HI/LO Lock-out:** Make sure the lockout dial is in the unlocked position (horizontal) or the switch is set to OFF. * **Attendant Control Pad (ACP):** Ensure the lockout LED on the ACP is OFF by toggling the individual function lockout. * **Wire Connections:** Check for and connect any loose cable couplings or power supplies.
  • S
    Stephanie Figueroa DDSAug 18, 2025
    Why my Invacare Medical Equipment bed does not stay in place?
    • K
      Kevin MeadowsAug 18, 2025
      If your Invacare Medical Equipment bed is not staying in place, here's what you should check: 1. **Floor Lock:** Ensure the floor lock is fully engaged. The green plunger should not be visible. 2. **Floor Condition:** Clean the surrounding floor area to remove any loose material or debris that might be reducing friction between the floor lock foot bumper and the floor.
  • M
    Mrs. Jacqueline Phillips MDAug 28, 2025
    How to level Invacare Carroll CS7 Medical Equipment bed?
    • M
      Matthew CrawfordAug 28, 2025
      To address a bed that is not level, raise the Invacare Medical Equipment bed to its highest position or lower it to its lowest position.

Summary

Safety

General Guidelines

Provides essential safety precautions and warnings for operating the bed safely and avoiding injury.

Technical Data

Typical Product Parameters

Lists key specifications and parameters for different CS bed models, including dimensions and certifications.

Setup

Unpacking Instructions

Installing the Mattress Keeper Rod to the Head and Foot Decks

Details the process of installing mattress keeper rods to prevent patient entrapment by securing the mattress.

Installing the Head and Foot Ends

Usage

Pendant Operation

Explains how to operate the bed's functions using the hand pendant control, including safety warnings.

Raise and Lower the Heel Lift Ratchet

Foot Pad Lock Mechanism

Bed Steer Mechanism

Options

Bed Rails and Positioning Devices

Optional Cardiopulmonary Resuscitation (CPR) Release

Optional 39 Inch and 42 Inch Wide Decks

Adjustable Width Bed Model CS9 FX600

Focuses on the CS9FX600 model's adjustable width feature and important considerations for its use.

Adjusting the CS9 FX600 Bed Width

Provides step-by-step instructions for adjusting the bed width on the CS9FX600 model to the desired setting.

Adjusting the Head Board Width for CS9 FX600

Maintenance

Cleaning

Provides detailed instructions for safely cleaning the bed components, including precautions for electrical parts.

Annual Maintenance Check

Outlines essential checks for the bed's control panel, wiring, grounding, and mechanical parts.

Quarterly Maintenance Check

Specifies periodic checks for battery function and general bed condition to ensure ongoing safety and performance.

Troubleshooting

Troubleshooting

Offers solutions for common bed issues such as not staying in place, leveling problems, and actuator malfunctions.

Invacare Carroll CS7 Specifications

General IconGeneral
BrandInvacare
ModelCarroll CS7
CategoryMedical Equipment
LanguageEnglish

Related product manuals