Invacare Get-U-Up - Page 11

INSTALLATION
Part No. 1148115 11 Get-U-Up
™
Lift
NOTE:Besurethattheshoulderboltiscompletelythroughtheholesofthemastassemblyandhorn
assembly,andtheyarenotridingontheshoulderofthebolt.Thenylonwashersmustsitbetween
thehornbushingandhornmountinglugs.
CAUTION
When assembled, the horn and mast assemblies MUST pivot easily.
10. Tightentheshoulderboltandlocknut.Thelocknutandshoulderboltcanbetightened
completely.
NOTE:Thehornassemblywillpivoteasilyifthemountinghardwareisalignedproperlywhenthe
hornassemblyissecuredtothemast.Tocheckforcorrectalignmentofthehardware,usetheAllen
wrenchprovidedandturntheshoulderboltbyhand(itshouldrotatewithoutalotofforcebeing
applied).Ifexcessiveforceisnecessary,theshoulderboltisNOTalignedproperly.Disassembleand
repeatassemblyprocedur esuntilproperalignmentisobtained.
11. Tocheckfortightnessofthelocknutandshoulderbolt:
A. Raisethehornassembly.
B. Pushthecontrolhandleawayfromthepumpassembly.
C. Ifthehornassemblypivotseasily,thelocknutandshoulderboltarenottootight.
D. Ifthehorn assemblydoesnotpivoteasilyordoesnotpivotatall,thelocknutand
boltarenotalignedproperly.Repeatssteps7to11.
12. Removetheshoulderboltandlocknutfromthecylinderlugsonthehornassembly.
13. Aligntheholesofthecylinderlugsandthecylinderrod.
14. Inserttheshoulderboltcompletelythroughtheholes.
15. Tightenthelocknutandshoulderbolt.
Download from Www.Somanuals.com. All Manuals Search And Download.