Invacare Get-U-Up - Section 2- Installation; Assembling the Base, Mast and Horn Assembly

INSTALLATION
Get-U-Up
™
Lift 10 Part No. 1148115
SECTION 2— INSTALLATION
Assembling the Base, Mast and Horn Assembly
 WARNING
The mast may be removed from the base for storage or transporting. Each time the
mast is removed and returned to the socket of the base, the mast MUST be locked
into the socket of the base assembly.
NOTE:Forthisprocedure,refertoFIGURE 2.1andFIGURE 2.2onpage12.
1. Unpackthecomponentsfromtheshippingcartons.
2. Removethelockingscrewfromthebottomofthebase.
3. Matchthenotchatthebottomofthemastassemblywiththetabsinsidethesocketof
thebaseassembly.
4. Insertthemastassemblyintothesocketandontothetabs.
5. Attempttoturnthemastassembly.
NOTE:Ifthemastdoesnotturn,themastiscenteredandlockedinplace.
6. Insertthelockingscrewintothebottomofthebaseandtightensecurely.
FIGURE 2.1 Assembling Mast to Base
7. Removetheshoulderbolt,steelwashers,nylonwashers,and
locknutfromthehorn
mountinglugsatthetopofthemastassembly.
8. Aligntheholesofthehornmountinglugsandthehornbushing.
9. Inserttheshoulderboltcompletelythroughtheholesofthehornmountinglugs,horn
bushing,nylonwashersandsteelwashers.RefertoFIGURE 2.2onpage12.
Mast
Notch
Locking
Screw
Socket
Tab
Download from Www.Somanuals.com. All Manuals Search And Download.