Invacare LYNX LX-3 - Replacing On-Board Battery Charger

Part No. 1090132 Rev F 61 Invacare Scooters
REPLACING ON-BOARD BATTERY CHARGER (FIGURE 11)
1. Remove seat. Refer to REMOVING/INSTALLING SEAT in PROCEDURE 5 of this
manual.
2. Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD
in PROCEDURE 9 of this manual.
3. Remove the floor basket. Refer to REMOVING/INSTALLING THE FLOOR BASKET
in this procedure of the manual.
4. Pull on-board battery charger partially out of front shroud.
5. Disconnect blue connector of on-board battery charger from blue connector of
battery wiring harness.
6. Disconnect white connector of on-board battery charger from white connector of
battery wiring harness.
7. Remove the EXISTING on-board battery charger.
8. Install NEW on-board battery charger by reversing STEPS 1-7.
FIGURE 11 - REPLACING ON-BOARD BATTERY CHARGER
On-Board
Battery
Charger
White
Connectors
Blue
Connectors
Front
Shroud
OPTIONS/REPLACEMENT PARTS PROCEDURE 11
OPTIONS/REPLACEMENT PARTS
All manuals and user guides at all-guides.com
all-guides.com