Invacare Platinum IRC9LXO2AWQ

Questions and Answers

C
Chad JohnsonAug 5, 2025
How to fix Invacare Platinum IRC9LXO2AWQ when no lights are on and it beeps?
- J
  Julie WilsonAug 5, 2025
  If your Invacare Oxygen Equipment shows no lights or intermittent flashing lights with short beeps and long pauses, it indicates a main power loss. First, ensure the power cord is properly plugged into the outlet. Next, check your house circuit breakers or fuses. If the problem continues, try a different outlet. You can also try pushing/resetting the circuit breaker; if it trips again, contact your service provider. If the unit has overheated, turn it off and let it cool down. Then, clean the cabinet filters and ensure the concentrator is at least 30.5 cm (12 in) away from walls, draperies, or furniture. If the issue persists after these steps, call your service provider.
D
Destiny RobertsonAug 13, 2025
What to do if the red light is on continuously on Invacare Oxygen Equipment?
- P
  Peter ButlerAug 13, 2025
  If the red light is continuously illuminated on your Invacare Oxygen Equipment, it signals a system failure. This can be due to the unit overheating because of blocked air intake, insufficient power at the outlet, or internal repairs being required. Ensure that the cabinet filters are clean and the oxygen concentrator is at least 30.5 cm (12 in) away from walls, draperies, or furniture to prevent overheating. Avoid using extension cords; instead, try a different electrical outlet or circuit. If the problem persists, contact your service supplier, as internal repairs may be needed.
P
Paul DixonAug 21, 2025
Why is the yellow light on with beeping on my Invacare Oxygen Equipment?
- D
  Douglas CarterAug 21, 2025
  If your Invacare Oxygen Equipment displays a yellow light with short beeps and long pauses, it indicates a system failure, potentially due to low oxygen purity, kinked or blocked tubing, cannula, or humidifier, or the flowmeter being set too low. Begin by cleaning or replacing the filters. Then, inspect for any kinks or blockages in the tubing and replace or correct as necessary; after doing so, turn the power off for 60 seconds, then back on. Also, ensure the flowmeter is set to 1.0 L/min or higher. Refer to the specifications for details.
L
laurabryantAug 28, 2025
What to do if Invacare Platinum IRC9LXO2AWQ Oxygen Equipment has a green light and beeping?
- S
  Sherry WilliamsAug 28, 2025
  If your Invacare Oxygen Equipment shows a green light with rapid beeping, it indicates a potential obstruction. This could be due to an internal obstruction in the oxygen path, such as kinked or blocked tubing, cannula, or humidifier, or the flowmeter being set at 0.5 L/min or less. Inspect for any kinks or blockages and correct, clean, or replace the affected item. After correcting the issue, turn the power off for 60 seconds and then back on. Also, ensure the flowmeter is set to the prescribed flow rate.

Summary

General Information

1.1 Symbols and Indicators

Explains signal words, product symbols, and oxygen purity indicator lights.

1.2 Intended Use

Defines the purpose and application of the Invacare Platinum Oxygen Concentrator.

1.3 Indications, Description, and Contraindications

Specifies use cases, describes the device, and lists contraindications.

Safety

2.1 Label Locations and General Guidelines

Identifies safety labels and provides essential guidelines for safe operation.

2.3 Radio Frequency Interference

Discusses EMC compliance and potential interference from wireless equipment.

Components

3.1 Component Identification

Illustrates and names the various parts and connectors of the oxygen concentrator.

3.2 Pneumatic Diagram

Shows the airflow path through the concentrator, with and without a humidifier.

Accessories

4.1 Optional Accessories

Lists and describes optional accessories for the oxygen concentrator.

Setup

5.1 Unpacking and Inspection

Guides users through safely unpacking and inspecting the oxygen concentrator.

5.3 Storage

Provides guidelines for storing the oxygen concentrator properly when not in use.

Usage

6.1 Introduction and Location Selection

Introduces the concentrator and guides on selecting a safe operating location.

6.3 Setting Up the Concentrator

Outlines the initial steps for connecting the concentrator and humidifier.

6.3.2 Connecting Nasal Cannula

Explains how to connect and safely position the nasal cannula for oxygen delivery.

6.3.3-6.3.4 Operation

Details powering on the concentrator and setting the correct oxygen flow rate.

6.3.5-6.3.8 Indicators and Meters

Explains oxygen purity indicators, startup, and the hour meter.

Maintenance

7.2-7.3 Cabinet and Filter Cleaning

Provides instructions for cleaning the concentrator cabinet and its air filters.

7.4-7.5 Humidifier and Patient Care Cleaning

Details cleaning procedures for humidifiers and between patients for hygiene.

7.6 Preventive Maintenance Checklist

A checklist for recommended preventive maintenance tasks and schedules.

Troubleshooting

9.1 Troubleshooting

Lists common problems, their causes, and step-by-step solutions for the concentrator.

Technical Data

10.1 Specifications

Presents detailed technical specifications of the oxygen concentrator.

10.2 Electromagnetic Compliance (EMC)

Details the device's compliance with electromagnetic compatibility standards.

Warranty and Support

11.1 Customer Service and Warranty Information

Provides contact information and warranty details for customer support.

Invacare Platinum IRC9LXO2AWQ Specifications

General

Operating Frequency	60 Hz
Weight	54 lb (24.5 kg)
Operating Voltage	120 V
Alarms	Power Failure, Low Oxygen Concentration
Operating Humidity	15% - 95% (non-condensing)