To Next PageTo Next Page
Why is my Invacare Pronto M51 Wheelchair joystick erratic?
If your Invacare Wheelchair joystick is erratic or not responding as desired, it could be due to an electrical malfunction or improper controller programming. Contact your dealer or Invacare for service, or reprogram the controller.
What causes Invacare Pronto M51 Wheelchair batteries to draw excessive current when charging?
Excessive current draw during charging of your Invacare Wheelchair batteries often indicates battery failure. Have the batteries checked for a shorted cell and replace them if necessary.
What to do if my Invacare Pronto M51 will not drive?
If your Invacare Wheelchair won't drive, there are several potential causes: * Ensure that the motor release levers are engaged. * Charge the batteries, making sure the charger setting is correct. * Unplug the charger from the wall outlet before attempting to operate the wheelchair. * Reset the circuit breaker. If it trips again, it may indicate an internal repair is needed, so contact your dealer or Invacare.
What does it mean if the power indicator is off on my Invacare Wheelchair, even when recharging?
If the power indicator on your Invacare Wheelchair is off, even while recharging, it suggests an electrical malfunction. Contact your dealer or Invacare for service.
Why does the charger indicator show low charge on my Invacare Pronto M51 after charging?
If the charger indicator shows a low charge level immediately after charging your Invacare Wheelchair, it might be due to weak batteries, an electrical malfunction, or a charger malfunction. You may need to replace the batteries or the charger. For electrical malfunctions, contact your dealer or Invacare.
What to do if battery indicator flashes low charge on Invacare Pronto M51 after recharging?
If the battery indicator on your Invacare Wheelchair flashes a low charge level immediately after recharging, it could be due to weak batteries or a charger malfunction. Consider replacing the batteries or the charger. For electrical malfunctions, contact your dealer or Invacare.
How to increase driving distance of Invacare Wheelchair?
To maximize the driving distance of your Invacare Wheelchair: * Ensure batteries are charged for at least 8 hours, ideally overnight, and that the charger setting is correct. * If the batteries are weak and not holding a charge, consider replacing them.
General| Type | Power Wheelchair |
|---|---|
| Drive System | Rear-Wheel Drive |
| Frame Material | Steel |
| Wheel Type | Solid |
| Footrests | Swing-away |
| Brakes | Electromagnetic |
| Colors Available | Red, Blue, Silver |
| Weight Capacity | 300 lbs |
| Seat Width | 18 in |
| Overall Width | 24 in |
| Maximum Speed | 4 mph |
| Drive Wheel Size | 10 in |
| Seat Height | 19 inches (48 cm) |
| Motor | 24V DC motors |
| Tires | Solid |
| Seat Depth | 18 in |
| Battery | NF-22 (2 Required) |
Procedures for setting up or repairing the electronic control unit.
Guidance on adjusting performance and general operation practices.
Information pertaining only to the M61 model.
Information on compatible accessories for the wheelchair.
Details on battery types, handling, and charging procedures.
Guidance on proper grounding procedures for safety.
Information on the wheelchair's performance in rainy conditions.
Warnings against using the chair for weight training and its maximum weight capacity.
Introduction to electromagnetic interference and its potential effects on powered wheelchairs.
Classification of common sources of radiated electromagnetic interference.
Maintaining stability and balance during operation.
Techniques for successfully navigating common obstacles.
Guidance for individuals assisting wheelchair users.
Warning about pinch points specifically on the M61 model.
Detailed procedure for safely lifting and moving the wheelchair via stairs.
Safe procedures for transferring between the wheelchair and other seating.
Safety considerations for weight distribution and reaching movements.
Warning about leaning backward and its effect on stability.
Regular maintenance and initial safety inspection procedures.
Checklist for initial inspection and adjustment of all wheelchair components.
Items to inspect on a weekly basis.
Items to inspect on a monthly basis.
Items to inspect periodically.
Specific initial inspection points for the M61 model.
Checks for the proper functioning of the elevate system.
Identifies common symptoms, causes, and solutions for wheelchair problems.
Solutions for erratic joystick response or unresponsive commands.
Specific troubleshooting for M61 when the seat is elevated.
Step-by-step guide to powering the M50/M51 wheelchairs on and off.
Instructions for powering the M61 wheelchair on and off.
How to use the joystick for driving and speed control.
How to maneuver the wheelchair using the joystick (forward, reverse, turns, stop).
How to adjust the speed using the speed control knob on M50/M51 models.
How to adjust speed settings for M61 models in different modes.
Instructions for activating the wheelchair's horn.
Safety precautions and operational guidance for the elevating seat.
How to use the joystick to control seat elevation on M61 wheelchairs.
Explanation of SPJ joystick components and their functions.
How to read the information gauge for power status and battery charge.
Interpretation of fault codes indicated by the information gauge LEDs.
Diagram identifying switches and indicators on SPJ+ and SPJ+ w/ACC joysticks.
Explanation of On/Off button, speedometer, and speed control buttons.
How the mode button functions on specific joystick models.
Further details on joystick control and the charging port.
Understanding the service indicator and information gauge for diagnostics.
Table detailing the meaning of various LED displays on the information gauge.
Procedures for removing and installing the wheelchair armrests.
How to adjust the width of the armrests.
How to adjust the angle of the armrests.
How to adjust the height of the armrests.
Procedures for installing and removing flip back armrests.
Steps for removing flip back armrests.
How to position flip back armrests for user transfers.
How to position flip back armrests for regular use.
How to adjust the height of flip back armrests.
Step-by-step instructions for adjusting seat back angles.
How to adjust the headrest for semi-reclined seating.
Detailed steps for removing and installing the complete seat assembly.
Warning that ASBA seat depth adjustment must be done by a technician.
Steps for adjusting the seat depth on Van Seat models.
How to adjust the seat height on M50/M51 models.
How to adjust the seat position on the base for different models.
Procedures for replacing the seat positioning strap.
How to adjust seat height for M61 Van Seat models using spacers.
Steps to reduce seat height for M61 wheelchairs by removing spacers.
How to adjust seat height for M61 ASBA seats using spacers.
Steps to reduce seat height for M61 ASBA seats by removing spacers.
Warning about ASBA seat position adjustments requiring a technician.
How to adjust the seat position on the base for Van Seat models.
Table and diagrams showing proper seat post mounting positions based on weight.
Steps to replace the seat positioning strap on Van Seats.
Steps to replace the seat positioning strap on ASBA seats.
Procedures for removing and installing the footboard assembly.
How to adjust the angle of the footboard assembly.
How to adjust the depth of the footboard assembly.
Steps for installing and removing front rigging components.
How to adjust the footrest height for the PHWH93 model.
How to adjust footrest height for PH904A and PHAL4A models.
Steps for replacing the heel loops on the footrests.
How to raise and lower elevating front riggings.
Adjusting telescoping front rigging supports for office style seats.
Securing the telescoping front rigging supports for office style seats.
Adjusting telescoping front rigging supports for standard seats.
Adjusting telescoping front rigging supports for ASBA seats.
Positioning telescoping front rigging supports for ASBA seats.
Warning against replacing flat free tires, requiring a qualified technician.
Steps to remove and install the top shroud of the wheelchair.
How to engage and disengage the motor release levers.
Procedure for replacing caster assemblies.
How to adjust the caster forks for proper operation.
Safety precautions for handling and replacing wheelchair batteries.
Guidance on using the correct battery types and configurations.
Procedures for removing and installing batteries from the tray.
How to connect and disconnect battery cables safely.
Detailed instructions for charging the wheelchair batteries.
Procedures for removing and installing the joystick assembly.
How to reposition the joystick mounting bracket for different seat types.
How to connect and disconnect the joystick cable from the controller.
How to adjust and operate the retractable joystick mount.
How to install the crutch or cane holder accessory.
Instructions for installing the oxygen cylinder holder.
How to install and use the walker holder.
