Why is my Invacare Wheelchair turn sluggish?
To address sluggish turning or performance issues with your Invacare Wheelchair, examine the tires for uneven wear. Also, check for a bent fork or frame, and ensure all hardware is properly tightened.
What to do if my Invacare Wheelchair veers left or right?
To correct an Invacare Wheelchair that veers to the left or right, check for loose stem nuts and bolts. Also, inspect the bearings for looseness or signs of wear.
General| Type | Power Wheelchair |
|---|---|
| Range | 15 miles |
| Weight Capacity | 300 lbs |
| Seat Depth | 16 in |
| Maximum Speed | 5 mph |
| Drive Wheels | 14 in |
| Caster Wheels | 6 in |
| Base Length | 43 in |
| Ground Clearance | 3 in |
| Back Height | 20 in |
| Battery Charger | off-board |
| Overall Length | 43 in |
| Drive System | Rear-wheel drive (RWD) |
| Battery | 2 x 12V U1 (Group 22NF) or 2 x 12V 50Ah (Group 22NF) |
Defines signal words (DANGER, WARNING, CAUTION, IMPORTANT) used in the manual for hazards.
Lists manual part numbers for additional referenced documents.
Details warranty terms, duration, and exclusions for products sold outside Canada.
Details warranty terms and exclusions for products sold in Canada.
Provides crucial instructions on reading manuals, seeking qualified assistance, and using Invacare accessories.
Emphasizes that initial setup and adjustments must be done by qualified technicians.
Warns against operating on roads and provides guidance on transport systems and compliance.
Warns against using stairways and escalators for occupied wheelchairs.
Instructs users and technicians on safety precautions before servicing.
Discusses safe handling, maneuverability, and user/assistant responsibilities.
Warns about seat positioning strap and safe use on inclines and obstacles.
Guides on navigating curbs, obstacles, and ramps safely.
Identifies pinch point hazards on the wheelchair, especially with footboard assembly.
Warns about ground clearance and correct use of footplates.
Provides safety instructions for reaching forward and maintaining balance.
Advises on safe backward reaching and maintaining stability.
Outlines safety procedures for transferring, including power and motor lock engagement.
Warns against storing or using the wheelchair near flames, and cautions about moisture.
Emphasizes not cutting grounding plugs and proper grounding practices.
Recommends deep cycle gel cell batteries and reading battery/charger information.
Provides critical safety warnings for charging batteries, including extension cord use.
Refers to Technical Data for weight limits and warns against exceeding them.
Explains EMI susceptibility and potential effects on the wheelchair's operation.
Shows the location of various labels on the wheelchair, including serial number and weight capacity.
Presents typical product parameters for different wheelchair models.
Lists overall dimensions for various wheelchair models.
Details specifications for Seat, Wheels, Battery, and Axle components.
Lists specifications for Footrests and Weight limitations for different models.
Guides on adjusting the joystick mounting tube for optimal user position.
Explains how to turn the wheelchair power on and off using different joystick types.
Describes how to use the joystick for proportional speed and direction control.
Details the various switches and indicators on the SPJ+ joystick control.
Covers the On/Off switch, LCD display, and drive select toggle.
Explains how to access and use user settings for date/time, battery voltage, fault codes.
Details how to select modes and when to charge batteries.
Explains the Information Gauge and Battery Gauge Displays for battery status.
Provides warnings and cautions for charging batteries, including unsealed battery precautions.
Explains how to engage/disengage motor locks for free-wheeling or joystick operation.
Guides on engaging and disengaging wheel locks for pushing the wheelchair.
Provides instructions for removing and installing the footboard.
Details crash testing, compliance, and recommendations for vehicle transport.
States compliance with ANSI/RESNA WC/Vol. 1 - Section 19.
Lists model, motor, and weight limits for TDX SI related to transport.
Shows recommended clear zones for occupants restrained by belts during travel.
Illustrates tie-down brackets and guides on attaching WTORS.
Guides on installing and orienting the pelvic belt for vehicle-anchored upper torso belts.
Rates wheelchair suitability for vehicle-anchored belts and provides stability test results.
Advises ensuring seating system security and proper pelvic belt angles.
Lists checks to perform upon delivery to ensure proper setup and condition.
Provides a checklist for weekly inspection of casters, tires, fasteners, and powered functions.
Lists monthly checks including cleaning, upholstery, and fasteners.
Details periodic checks for alignment, fasteners, upholstery, grips, and labels.
Recommends professional service inspections every six months.
Specifies replacement of motor brushes and gearbox coupling every 18 months.
Recommends qualified technicians for battery installation and replacement, and safety precautions.
Details correct battery terminal configuration and warnings for 22NF batteries.
Provides instructions for removing and installing batteries and related components.
Guides on reinstalling shrouds and retention brackets after battery installation.
Details the procedure and tools required for replacing batteries and cables.
Provides instructions and warnings for cleaning battery terminals.
Explains how to adjust caster forks to prevent flutter and ensure smooth movement.
Guides on adjusting the footboard angle using jam nuts and set screws.
Details repositioning the joystick assembly for adjustable ASBA seats.
Explains how to reposition the joystick assembly for van seats.
Guides on safely disconnecting and connecting joystick connectors.
Provides solutions for common driving performance issues like veering and sluggishness.
Mentions referring to Electronics Manual for error codes related to electrical issues.
Explains diagnostic meanings of LED patterns on the information gauge.
Lists error codes based on service indicator flashes and their solutions.
Details error codes and solutions for CMPJ+ joysticks and displays.
Provides 'Do's' and 'Don'ts' for checking battery charge and maintenance.
To Next Page
