INVENTIA MT-301 - Calling Time; CLIP Call Rule; Recipient Number; Trigger Flag

41
7.2.6.3.4. CLIP call rule
Each of rules residing on the list is defined by following parameters:
 Trigger input
 Trigger flag
 Recipient number
 Calling time
7.2.6.3.4.1. Trigger input
Function - defines resource to observe
Data type - selection list
List - n/a
the rule is inactive
I1…I8
binary inputs
Q1, Q2
binary outputs
A1, A2, A3_MUX…A6_MUX
analogue inputs
FS1_ups, FS1_gprs
system trigger inputs
TMR1, TMR2
timer trigger inputs
Default
value
- n/a
Comments - more about trigger inputs and flags in chapter Appendices
7.2.6.3.4.2. Trigger flag
Function - defines event-triggering flag associated with selected
trigger input
Data type - selection list
Range - n/a
rule inactive
Bi In 0->1, Bi In 1->0
binary input state change
Counter
counter flip over (up or down)
An LoLo, An Lo, An Hi, An HiHi
alarm threshold flags for analogue inputs signals
Default
value
- n/a
Comments - more about trigger inputs and flags in chapter Appendices
7.2.6.3.4.3. Recipient number
Function - selects CLIP call recipient number
Data type - selection list
List - friendly recipient names associated with phone numbers in
Authorized numbers list
Default
value
- NUM 1 - first number on the list