Whilst the installation of a Piccolo audiometer is a relatively simple
procedure, it should be entrusted to a person with the requisite skills. If the
installation is not performed correctly, the system could be affected by safety
problems when in use.
This chapter describes the procedure for installing the system.
Keep the packaging materials, in case the audiometer should
need to be sent to the dealer or to Inventis for any reason.
PRECAUTIONS
Like any other electric or electronic device, the Piccolo audiometer will emit
electromagnetic waves. Even though its emissions are within the limits of
standards, other electronic devices close to the audiometer might be affected,
if particularly sensitive to electromagnetic interference.
Should this occur, check just by switching the audiometer OFF and ON and
try to eliminate the interference using one or more of the following solutions:
- change the orientation and/or the position of the device affected by
interference;
- distance the affected device from the audiometer;
- plug the affected device into a power socket on a circuit other than the
circuit to which the audiometer is connected;
- consult the manufacturer or a service centre for assistance.
CONNECTIONS
All connection points for accessories are located on the rear panel, as also is
the power switch. This section refers to the Piccolo Speech audiometer. The
Piccolo Plus does not have a LINE IN connector for an external sound source
(following reported as EXT1, EXT2). The Basic model also lacks a BC
connector (for a bone vibrator).
To Next Page
Loading...
Need help?
General
